|
3Com
| 3C1000B-T
| Broadcom BCM5702CKFB
| PCI 32/66
| Gigabit Ethernet
| TP RJ45: 10Base-T, 100Base-TX, 1000Base-T
|
Linux 2.4.26
dmesg
tg3.c:v2.9 (March 8, 2004)
eth1: Tigon3 [partno(3C1000B-T) rev 1002 PHY(5703)] (PCI:33MHz:32-bit) 10/100/1000BaseT Ethernet 00:0a:5e:00:38:d0
tg3: eth1: Link is up at 1000 Mbps, full duplex.
tg3: eth1: Flow control is off for TX and off for RX.
tg3: eth1: Link is down.
tg3: eth1: Link is up at 1000 Mbps, full duplex.
tg3: eth1: Flow control is on for TX and on for RX.
lspci
02:0c.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5702X Gigabit Ethernet (rev 02)
Subsystem: 3Com Corporation: Unknown device 1100
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (16000ns min), cache line size 08
Interrupt: pin A routed to IRQ 9
Region 0: Memory at bd000000 (64-bit, non-prefetchable) [size=64K]
Capabilities: [40] PCI-X non-bridge device.
Command: DPERE- ERO- RBC=0 OST=0
Status: Bus=0 Dev=0 Func=0 64bit- 133MHz- SCD- USC-, DC=simple, DMMRBC=0, DMOST=0, DMCRS=0, RSCEM-
Capabilities: [48] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [50] Vital Product Data
Capabilities: [58] Message Signalled Interrupts: 64bit+ Queue=0/3 Enable-
Address: fffffbfff7fff9dc Data: feff
02:0c.0 Class 0200: 14e4:16a6 (rev 02)
00: e4 14 a6 16 06 00 b0 02 02 00 00 02 08 40 00 00
10: 04 00 00 bd 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 b7 10 00 11
30: 00 00 00 00 40 00 00 00 00 00 00 00 09 01 40 00
|